Rapid wear is caused by factors such as the machining, assembly, and adjustment of new machine parts, resulting in rough friction surfaces, small contact areas at mating surfaces, and uneven surface pressure. During machine operation, the uneven parts on the surface of the parts interlock and rub against each other, and the metal debris worn off acts as abrasive, further accelerating the wear of the mating surfaces. Therefore, the break-in period is prone to rapid wear of parts (especially mating surfaces). Overloading during this period can lead to damage to parts and premature failure.
Poor lubrication is also a problem. Newly assembled parts have small clearances, and due to assembly and other reasons, it is difficult to ensure uniform clearance. Lubricating oil (grease) cannot easily form a uniform oil film on the friction surfaces to prevent wear. This reduces lubrication efficiency and causes premature abnormal wear of machine parts. In severe cases, it can cause scratches or seizing on precision-fitted friction surfaces, leading to malfunctions.
Loosening of newly machined and assembled parts can occur due to deviations in geometry and dimensional fit. During the initial use, these parts are prone to loosening due to alternating loads such as impact and vibration, as well as factors like heat, deformation, and rapid wear.
Leakage can also occur due to loosening of parts, vibration, and heat. This can lead to leaks at sealing surfaces and pipe joints. Some casting and machining defects may be difficult to detect during assembly and debugging, but these defects are exposed by vibration and impact during operation, manifesting as oil (water) leakage. Therefore, leakage is common during the break-in period.
Operational errors, often due to insufficient understanding of the machine's structure and performance (especially for new operators), can easily cause malfunctions or even mechanical accidents.







